Engineering characteristics
Zhengchang Lvbao DW series belt dryer

I. Product introduction:
The advanced technologies of hot air independent cycle unit structure, mesh belt to drive materials to run horizontally, hot air blowing materials vertically are adopted for DW series belt dryer, with high heat energy utilization rate, low temperature drying, small wear loss, etc.

II. Product parameters:

Specifications and performance parameters of DW series single-layer belt dryer
Model	Units	Belt width  (m)	Drying section length  (m)	Drying intensity  (kg water/h)	Total power  (kw)	Boundary dimension  (L.W.Hmm)
DW-1.2-8	4	1.2	8	60-160	11.4	10.5*1.6*2.9
DW-1.2-10	5	1.2	10	80-220	13.6	12.5*1.6*2.9
DW-1.6-8	4	1.6	8	75-220	11.4	10.5*2*2.9
DW-1.6-10	5	1.6	10	95-250	13.6	12.5*1.6*2.9
DW-2-8	4	2	8	100-260	19.7	10.5*2.4*2.9
DW-2-10	5	2	10	120-300	23.7	12.5*2.4*2.9

Specifications and performance parameters of DW series double-layer belt dryer
Model	Units	Belt width  (m)	Drying section length  (m)	Drying intensity  (kg water/h)	Total power  (kw)	Boundary dimension  (L.W.Hmm)
DW-1.2-8	4	1.2	8	6-30	13.6	10.8*1.6*3.7
DW-1.2-10	5	1.2	10		15.8	12.8*1.6*3.7
DW-1.6-8	4	1.6	8		13.6	10.8*2*3.7
DW-1.6-10	5	1.6	10		15.8	12.8*2*3.7
DW-2-8	4	2	8		14.7	10.8*2.4*3.7
DW-2-10	5	2	10		16.9	12.8*2.4*3.7

III. Product features:
1. The advanced technologies of hot air independent cycle unit structure, mesh belt to drive materials to run horizontally, and hot air blowing materials vertically are adopted for this machin;e
2. It can be designed into horizontal flow and vertical flow, single layer or multi-layer structure as required; for single layer structure, thermal efficiency is lower, while for double-layer structure, thermal efficiency is higher;
3. Hot air is recycled and reused, with high thermal energy utilization;
4. The retention time and retention volume for the material in the dryer can be easily adjusted;
5. As the material retention time can be adjusted to the maximum, it can dry the material with very high moisture content, or dry the material requiring low temperature and long period of time for drying;
6. Materials and conveyor are relatively static, with few worn and crushed materials and little dust;
7. The materials with high moisture or viscous material shall be performed before drying;
8. The drying section is composed of several independent drying units, which can be increased or decreased economically and reasonably according to the need;
9. Convenient for operation and maintenance.